George P
member
- Joined
- Jan 10, 2018
- Messages
- 7,772
Finally getting a chance to set this up after moving. Mounted on an Inline riser, shell plate on, primer plate and seating punch good.
HOWEVER, before I attached primer tube assys, I held my eye over the top looking down. It isn't even close to being able to pick up a primer. The bent bar that actuates the slide, etc, doesn't move the primer slide far enough - as in the opening doesn't line up at all. The top black screw is set at max. I can manually manipulate the best metal bar back enough to get the clearance. What am I missing? (Besides the fact that the directions are less than clear)
TIA!
HOWEVER, before I attached primer tube assys, I held my eye over the top looking down. It isn't even close to being able to pick up a primer. The bent bar that actuates the slide, etc, doesn't move the primer slide far enough - as in the opening doesn't line up at all. The top black screw is set at max. I can manually manipulate the best metal bar back enough to get the clearance. What am I missing? (Besides the fact that the directions are less than clear)
TIA!