Looking at different knives, I saw this cool little beauty.
Which reminded me of this knife that I own.
I was thinking about drawing a line, from where the bottom of the hump is over the spyderco eye, to the tip of the blade. Then grinding 3 grooves into the blade like on the one above.
I figure 3 as the first would have to match the grind of the blade. Two more the same size would probably take it to the top.
Which would be better idea for removing metal, disk, stone or metal bit in a dremel? Ideas? I didn't want to heat the blade any more then necessary.
Which reminded me of this knife that I own.
I was thinking about drawing a line, from where the bottom of the hump is over the spyderco eye, to the tip of the blade. Then grinding 3 grooves into the blade like on the one above.
I figure 3 as the first would have to match the grind of the blade. Two more the same size would probably take it to the top.
Which would be better idea for removing metal, disk, stone or metal bit in a dremel? Ideas? I didn't want to heat the blade any more then necessary.