Hypnogator
Member
I'm in the process of upgunning from a Kel-Tec P-32 to a Kahr PM-45. (No half-measures for me!)
Anywho, I have a Pocket Slipper laser on my P-32, and am planning on putting an Armalaser on the Kahr. I have the P-32 zeroed to hit 1.5" above the laser dot, so that the bore is roughly parallel with the laser. I figure that with aiming time, it's no problem to put the dot slightly below point of aim, and if there's no time to aim, it'll be within Minute Of Badguy, anyway.
For those of you who use lasers, is this the best method, or do you zero the laser to cross point-of-aim at a certain distance? It would seem that doing so would make precision shooting far more difficult.
I want to keep the laser close to point-of-aim out to 25 yds.
Anywho, I have a Pocket Slipper laser on my P-32, and am planning on putting an Armalaser on the Kahr. I have the P-32 zeroed to hit 1.5" above the laser dot, so that the bore is roughly parallel with the laser. I figure that with aiming time, it's no problem to put the dot slightly below point of aim, and if there's no time to aim, it'll be within Minute Of Badguy, anyway.
For those of you who use lasers, is this the best method, or do you zero the laser to cross point-of-aim at a certain distance? It would seem that doing so would make precision shooting far more difficult.
I want to keep the laser close to point-of-aim out to 25 yds.