lagerratrobe
Member
Hi All,
Just signed up to this forum because I like the informative responses and general tone of the conversations I've read so far. I have a question related to a new Pietta replica of the 1858 Remington. Specifically, I'd like to know what the correct procedure is to lower the hammer into the safety notches on the cylinder. Can this be done from both half and full-cock?
Please note that I am NOT asking whether it is safe to use this feature. I merely want to know:
Thanks.
Just signed up to this forum because I like the informative responses and general tone of the conversations I've read so far. I have a question related to a new Pietta replica of the 1858 Remington. Specifically, I'd like to know what the correct procedure is to lower the hammer into the safety notches on the cylinder. Can this be done from both half and full-cock?
Please note that I am NOT asking whether it is safe to use this feature. I merely want to know:
- whether it's ok for me to continue dropping the hammer from half-cock
- whether I can decock from full-cock and index the cylinder to the safety notch position
Thanks.