So I’m playing with some 223 loads in an AR. I have a ton of mixed brass. I have been separating it as I process it.
I decided to load the RP brass first. But I’m doing all the work of processing everything and that sucks. So today I decided to load up some RP and then load 2 of several others to test.
So I loaded 5 RP, 2 LC, 2 FEderal
I wish I took a picture because my results are odd. The 5RP clustered in a 1” group dead center. The 2 LC printed a half moa group about 1.5” low and left. The 2 federal sprinter another 1/2 moa group about 1” below the RP.
It’s odd because the federals seemed to have the lowest case capacity. I’m not sure what to think of my poi change and not sure if I should Load them all and sort into lots or sort through em.
I decided to load the RP brass first. But I’m doing all the work of processing everything and that sucks. So today I decided to load up some RP and then load 2 of several others to test.
So I loaded 5 RP, 2 LC, 2 FEderal
I wish I took a picture because my results are odd. The 5RP clustered in a 1” group dead center. The 2 LC printed a half moa group about 1.5” low and left. The 2 federal sprinter another 1/2 moa group about 1” below the RP.
It’s odd because the federals seemed to have the lowest case capacity. I’m not sure what to think of my poi change and not sure if I should Load them all and sort into lots or sort through em.