Lennyjoe
Member
Got an issue that I figured you'd all could help me with.
Here's the issue. Im using once fired Winchester brass in a Lee Single stage press and Lee RGB 30-06 dies. I have cleaned the cases and lubed them accordingly. When I go to size and deprime the brass, the die will only let the neck go in about 1/4 of the way. First I thought I had the deprimer pin too low but thats not the case. I tried to take a pic but dont have a good enough cam so here's the best one I got.
Question is, how far down the neck do I need to go? Im assuming most all the way to the taper of the shell.
I have been reloading shotshell and now pistol rounds but just started trying out rifle rounds.
Standing by for words.....................
Here's the issue. Im using once fired Winchester brass in a Lee Single stage press and Lee RGB 30-06 dies. I have cleaned the cases and lubed them accordingly. When I go to size and deprime the brass, the die will only let the neck go in about 1/4 of the way. First I thought I had the deprimer pin too low but thats not the case. I tried to take a pic but dont have a good enough cam so here's the best one I got.
Question is, how far down the neck do I need to go? Im assuming most all the way to the taper of the shell.
I have been reloading shotshell and now pistol rounds but just started trying out rifle rounds.
Standing by for words.....................
Last edited: