Carbonator
Member
Hi there. Looking to get back into guns after a long layoff. I’d really like a snubby in 45 Long Colt or .44 Special to get started, probably a Taurus 450, S&W 296, or Charter Bulldog. I may customize a larger 45LC down to CCW size, as it is my preferred caliber but can't find many small LC revolvers on the market.
1. What is the difference between the Taurus “Ultralite†and “Total Titanium†models? They both are lightweight but only differ by an ounce or so. The Ultralite is apparently an alloy - is this an aluminum alloy frame and titanium cylinder?
2. Is the stainless steel used in revolvers nowadays completely rust free or are they still higher maintenance than the alloys?
3. How do you plug the ports on a snubby? Tap allen screw threads into the holes or weld the holes shut?
4. How do you shorten a barrel and how much does it typically cost to have done?
Thanks. Glad to be here.
1. What is the difference between the Taurus “Ultralite†and “Total Titanium†models? They both are lightweight but only differ by an ounce or so. The Ultralite is apparently an alloy - is this an aluminum alloy frame and titanium cylinder?
2. Is the stainless steel used in revolvers nowadays completely rust free or are they still higher maintenance than the alloys?
3. How do you plug the ports on a snubby? Tap allen screw threads into the holes or weld the holes shut?
4. How do you shorten a barrel and how much does it typically cost to have done?
Thanks. Glad to be here.