I really can't figure what all the fuss is about.
After learning that the pros of stainless pins in a thumler's FAR outway the cons of dry vibratory case cleaning I learned the low effort/high satisfaction method of drying my wet brass:
After rolling them back and forth in the large towel I dump them into a brass sorting plastic strainer and hang it above the exhaust side of the dehumidifier that dries out my basement. The air blowing out of the dehumidfier is both warm and dry. After a few hours or so,they are as dry as you could expect.
Simple, low effort, no additional cost. What's there to argue about?
After learning that the pros of stainless pins in a thumler's FAR outway the cons of dry vibratory case cleaning I learned the low effort/high satisfaction method of drying my wet brass:
After rolling them back and forth in the large towel I dump them into a brass sorting plastic strainer and hang it above the exhaust side of the dehumidifier that dries out my basement. The air blowing out of the dehumidfier is both warm and dry. After a few hours or so,they are as dry as you could expect.
Simple, low effort, no additional cost. What's there to argue about?