I have a question on the slide stop. I just bought a stainless CZ-75B and shot it for the first time last night. It is a sweet gun!!!
anyway, when stripping it to clean it and putting it back together, the slide stop doesnt sit flush to the side of gun frame. The long cylinder piece is inserted fine but the other end with the shorter square piece doesnt sit flush with the frame.
Is this normal?
To tap it out, I used a rubber mallet and lightly tapped out the slide stop. I couldn't remember if this piece was sitting flush when I bought the gun new. Grrr, I'm a little bit worried.
anyway, when stripping it to clean it and putting it back together, the slide stop doesnt sit flush to the side of gun frame. The long cylinder piece is inserted fine but the other end with the shorter square piece doesnt sit flush with the frame.
Is this normal?
To tap it out, I used a rubber mallet and lightly tapped out the slide stop. I couldn't remember if this piece was sitting flush when I bought the gun new. Grrr, I'm a little bit worried.