PsychoKnight
Member
- Joined
- Oct 21, 2006
- Messages
- 97
RCBS Low Primer Warning Interference LnL AP Powder Measure
I get about a 1mm interference between the low primer warning device and LnL powder measure whenever the carrier/primer tube travels up and down. The powder measure body is centered on the die so turning it doesn't create any additional clearance, and I've rotated the warning device in all positions as well, to no avail.
I was thinking of taking my chances with safety and extending the primer tube and protective piping by using pieces about double the orginal lengths. I prefer to determine alternate solutions before I go that route. I also like the measure at station 2 because I seat and crimp separately and can't use the 5th station for anything due to the ejection wire.
Aside from that, anybody have a usable workaround which doesn't entail to much fabrication?
I get about a 1mm interference between the low primer warning device and LnL powder measure whenever the carrier/primer tube travels up and down. The powder measure body is centered on the die so turning it doesn't create any additional clearance, and I've rotated the warning device in all positions as well, to no avail.
I was thinking of taking my chances with safety and extending the primer tube and protective piping by using pieces about double the orginal lengths. I prefer to determine alternate solutions before I go that route. I also like the measure at station 2 because I seat and crimp separately and can't use the 5th station for anything due to the ejection wire.
Aside from that, anybody have a usable workaround which doesn't entail to much fabrication?