Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

red rust in powder

Discussion in 'Handloading and Reloading' started by jimbeam, Jul 14, 2009.

Thread Status:
Not open for further replies.
  1. jimbeam

    jimbeam Member

    Joined:
    Feb 15, 2007
    Messages:
    107
    Found my first can of powder (IMR 4198) with rust in the powder. Kind of hangs in the air. New can from 1994 or so. Will dispose tomorrow, but I wonder if anyone ever found out what causes this, as the can seems to have rusted in the inside. Have a can of the same powder that is ten years older and is shiny on the inside. (only use this for reduced loads and 150 grain 30-30.)
     
  2. WNTFW

    WNTFW Member

    Joined:
    Jul 16, 2006
    Messages:
    1,906
    Sounds like the powder has gone bad. Is the powder rust colored? Or is it just the can? Does it smell bad also?
     
  3. jimbeam

    jimbeam Member

    Joined:
    Feb 15, 2007
    Messages:
    107
    Powder looks good, typical ether odor.
     
  4. KirbyAUS

    KirbyAUS Member

    Joined:
    Jun 30, 2009
    Messages:
    3
    Location:
    Adelaide, South Australia
    Rusty powder?

    Hi Jim,
    yes, if the powder is "rusty" it needs to be destroyed.
    I don't know chemistry well enough, but powder manufacturers use various chemical additives including calcium carbonate to stop the decomposition of nitrocellulous. Over long periods, nitrocellolose forms acids - and that's the most likely cause of your rusty dust!
    I don't understand why some does and some doesn't...

    Graphite is also used to coat the granuals to control the burn rate and minimise static buildup.
    So when you destroy the powder - don't follow the old advice of using it as fertiliser in your garden. It could take 10+ years to break down.
    I've experimented with doing just that - leaving a small pile im my garden for three years - it went up when I lit it!

    Pour it into small lines and burn it safely.

    Regards,
    Kirby.
     
  5. jimbeam

    jimbeam Member

    Joined:
    Feb 15, 2007
    Messages:
    107
    Yeah, I don't believe the fertilizer bit either. Burning maybe safest way, but I'll bet if you asked the EPA or DNR you won't get a straight answer. Thanks for the replys, guys.
     
  6. faire bien de...!

    faire bien de...! member

    Joined:
    May 10, 2009
    Messages:
    50
    A couple years ago a friend gave me a can of IMR-4227 and from the code printed on it, I think it's from 1977. I had never used that powder before, so I looked into what I could use it for. The best thing I came up with for myself was reduced loads in 30-06 with some lead bullets I bought. When I went to the range I was very pleased with the results, plus my tired '03 was happy to not have to work as hard. I was superised how fun and how accurate shooting those lead bullets could be with that powder. Anyhow, I was reading something sometime after about a reddish dust in old powder cans being rust and to not use it. Well, that IMR-4227 I was given was full of red dust! It had not crossed my mind that it was rust, I just thought it was some type of burn rate inhibiter or something. When I took a closer look inside the can, it sure enough was from the inside deteriorating. But, I guess my point is that the stuff shoots fine as far as I can tell and I've almost used the can up. It could be that it burns a bit slower with that dusty coating on it, so when I get a new can I'll start over with a lesser charge, and of course I wouldn't be firing that stuff in a new match gun or one that wasn't already somewhat worn out. My experience could also be that the stuff I have dosen't have "that" much rust in it to make a real differance, but if I had known it was rust before I fired it, I may not have at all.
     
  7. Sport45

    Sport45 Member

    Joined:
    Mar 5, 2004
    Messages:
    2,783
    Location:
    Houston, TX
    Try dumping it in a glass or stainless mixing bowl and swirling it around with a strong magnet. You might be able to remove the rust and save the powder.

    Don't try this with a plastic bowl or you'll have to buy the missus a new one because of the graphite stains.:uhoh:

    on edit: This suggestion is assuming you are sure the powder is okay and only needs the rust filtered out. If the powder smells acrid or if the granuals don't look right the powder should be tossed.
     
    Last edited: Jul 15, 2009
  8. Slamfire

    Slamfire Member

    Joined:
    Dec 29, 2006
    Messages:
    7,579
    Location:
    Alabama
    Your red powder is outgassing nitric acid gas. The acid gas is removing the lining from your can.

    Single based powders are made of nitrocellulose. Nitrocellulose decomposes to a lower energy molecule, releasing nitric acid gas. Nitroglycerine accelerates this decomposition, which is why the Army scraps double based powders at 20 years, 45 years for single base.

    These dates are based on risk. Powders go bad before and after these shelf life dates. I have some IMR 4064 powder that I bought new in Jan 1990. It has been stored in cool dry conditions. Little, rice kernel sized tarnish spots were all over the inside of the can. The old ether smell was gone. I am loading that powder up and going to be shooting it soon because it is on the way out.

    Your powder is on its last legs. The stuff will shoot, but it will also ruin cases. The nitric acid gas will cause green corrosion on bullets and create case neck cracks. I had to toss 700 LC match because the deteriorating surplus powder ruined the cases. Incidentally, the rate of the reduction/oxidation reaction increases over time.

    Deterioration may cause weird pressure curve shifts. As the powder chemistry changes through deterioration, the burn rate will change. For double based powders, the surface becomes NG rich, and the initial burn rate increases, even though the overall energy content of the powder is less. Which means you can have a pressure spike even though the exit velocity of the bullet is not abnormal.

    I am lacking information on single base powders, the Insensitive Munitions guy that I am learning from, he is not available. But based on my experience, I think the same issues happen in single base.

    I have shot deteriorated IMR 4895 and IMR 3031. The can from which the IMR3031 came from, when I poured the stuff into a measure, a cloud of red particles floated in the air! (I suspect only some of it was rust) The stuff shot well but I have had muzzle blasts of different sound/intensities. And I have had stiff bolt lifts with charges that were grains from maximum. Something is going on, and it is not good.

    There are people out there how believe the shelf life of gunpowder is infinite. This is not true.
     
    Last edited: Jul 15, 2009
  9. The Bushmaster

    The Bushmaster Member

    Joined:
    Jan 29, 2005
    Messages:
    7,850
    Location:
    Ava, Missouri
    WHAT?!!? BURN IT? YOU WANT TO HAVE TO PAY FOR "CARBON OFFSET? Let your grass have it. Even if you don't believe that the nitrate in the powder isn't good for your yard. At least it's not bad for it either...
     
  10. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    +1
    Normal good powder will not rust the inside of a powder can.

    It has or is going south.

    Dump it.

    rc
     
  11. jimbeam

    jimbeam Member

    Joined:
    Feb 15, 2007
    Messages:
    107
    I ran the powder "stir in the bowl with a magnet" thing by my better half, she was not impressed and would probably dispose of the powder in a place not to my liking. I had thought about this rust awhile, and concluded that for the rust to be there in the first place, bad things were going on. I am not in particular love with this powder anyway, it's gone.
     
  12. Offfhand

    Offfhand Member

    Joined:
    Apr 12, 2009
    Messages:
    1,177
    "Rusty" powder

    Had a good laugh at Sport45's sulution to rusty powder. What a great sense of humor he has, I though, and added his "cure" to my list of shooting jokes to tell my pals. Then it occured to me that he might have actually been serious and now I'm a bit worried. Tell us Sport45, you really were kidding weren't you?
     
  13. Bush Pilot

    Bush Pilot Member

    Joined:
    Oct 17, 2007
    Messages:
    1,611
    I had the same thing happen to me a couple of years ago, it made a nice quick "poof" when I set it on fire. It isn't worth trying to salvage.
     
  14. Sport45

    Sport45 Member

    Joined:
    Mar 5, 2004
    Messages:
    2,783
    Location:
    Houston, TX
    No, I've actually done that to salvage a few ounces of powder from one 8# can to mix with nearly full can that hadn't started rusting (same lot). I stored what was left in a clean antifreeze jug that I properly labled. In Houston everything rusts, I've even seen rust on the inside of camp fuel cans. The powder did not have a bad smell or appearance and it wasn't anywhere near 20 years old. Just rust from inside the can.

    That was quite a while ago. The ruined plastic mixing bowl is different story....
     
Thread Status:
Not open for further replies.

Share This Page