madkiwi
Member
I am building a precision AR with a Rock River stainless bull-barreled 20" upper, and with a Magpul Precision adjustable stock.
Topping it with a Super Sniper 10x42.
That's the known stuff. The unknown is- how high should I make the rings to get a good cheek weld? The Magpul stock is adjustable enough if the scope was too high, but what little info I have found on the usual sites indicates that the problem for an AR is that low mounts are more of a problem. Obviously one cannot lower the stock.
So what ring height should I be looking for? I was going to buy Warne Tactical Ultra-high rings (model 617, 0.85" high, solid steel) but figured I should do a little checking first.
Thanks
Topping it with a Super Sniper 10x42.
That's the known stuff. The unknown is- how high should I make the rings to get a good cheek weld? The Magpul stock is adjustable enough if the scope was too high, but what little info I have found on the usual sites indicates that the problem for an AR is that low mounts are more of a problem. Obviously one cannot lower the stock.
So what ring height should I be looking for? I was going to buy Warne Tactical Ultra-high rings (model 617, 0.85" high, solid steel) but figured I should do a little checking first.
Thanks