Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Scope Rings For H&R 223 Handi Rifle

Discussion in 'Shooting Gear and Storage' started by rugerman07, Nov 9, 2009.

Thread Status:
Not open for further replies.
  1. rugerman07

    rugerman07 Member

    Joined:
    Apr 6, 2007
    Messages:
    532
    Location:
    Southern Illinois
    I have a Nikon Prostaff 3-9x40 Matte BDC scope that I'm going to put on my H&R 223 Handi Rifle. Can anyone recommend a good set of rings for $20.00 or less?
     
  2. chestnut ridge

    chestnut ridge Member

    Joined:
    Aug 18, 2005
    Messages:
    321
    Location:
    south central Tennessee
    I have the same outfit with a 75 dollar 3x9 scope. I used some
    Weaver rings I found at Wal-Mart for 12 dollars. These are split
    vertically; but seem to be well finished and they don't look too
    bad. As if it mattered on a H&R.
     
  3. greyling22

    greyling22 Member

    Joined:
    Aug 6, 2007
    Messages:
    4,340
    Location:
    East Texas
    I used walmart weaver quad locks <$15 I think they were medium height. I had to use the hammer spur with them.
     
  4. rbernie
    • Contributing Member

    rbernie Member

    Joined:
    Jan 21, 2004
    Messages:
    20,556
    Location:
    Norra Texas
    The best rings for proper cheekweld on the HandiRifle are the Leupold Rifleman Weaver rings in low, available at WallyWorld for less than twenty bucks. However, your scope's ocular may not clear the hammer with the low rings and you may have to use the medium rings.
     
  5. Marty183

    Marty183 Member

    Joined:
    Nov 15, 2009
    Messages:
    100
    Location:
    North East
    Both suggestions work...The problem with ring heights is that they are not standard. I always try to mount the scopes as close to the barrel as possible but that darned hammer spur keeps things up there...
     
Thread Status:
Not open for further replies.

Share This Page