I have a DNZ one piece scope base to mount on a Browning X-Bolt. Info on ring torque 25 in/lbs; however, nothing on mounting the base to the rifle. I've tried Browning, Brownells, random internet searches - nada. Brownells referred to a engineering reference book for all the torque values by specific type mounting screws. Brownells reference site within their discussion is no longer available.
I've also tried to get info via gunsmith references and either it doesn't exist or I'm not finding the references.
The only info I have to go forward with is the screw is #8 hardened steel. It is a hex-head allen wrench screw with hole in the top.
Any advice/info will be greatly appreciated. I'm more than willing to buy such and engineering reference manual if I can find such a critter.
MapMan
I've also tried to get info via gunsmith references and either it doesn't exist or I'm not finding the references.
The only info I have to go forward with is the screw is #8 hardened steel. It is a hex-head allen wrench screw with hole in the top.
Any advice/info will be greatly appreciated. I'm more than willing to buy such and engineering reference manual if I can find such a critter.
MapMan