Rushthezeppelin
Member
So I'm about to start load workup for CFE223 and H335 under 55gr Dogtown HPs. CFE 223 is showing 26.0-28.0gr load range on the Nosler site. H335 shows 23.0-25.0gr on noslers site. Oddly enough my Lyman 49th shows 24.3-27.0 for H335. Unfortunately Hodgons reloading center site is down atm (404 error ) so I can't check them. Will be using CCI 41s in LC brass.
I was wondering though if anyone has good starting points for these that would be likely to cycle my action, a 16" carbine gas with SA BCG and standard buffer and spring. I'd rather not waste my time/components with loads that are too light to cycle the action. Anyone got some good minimums with these two powders to start my ladder testing with?
I was wondering though if anyone has good starting points for these that would be likely to cycle my action, a 16" carbine gas with SA BCG and standard buffer and spring. I'd rather not waste my time/components with loads that are too light to cycle the action. Anyone got some good minimums with these two powders to start my ladder testing with?