Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Swivel studs for Ruger 10/22 Liberty Training Rifle

Discussion in 'Shooting Gear and Storage' started by evolve23, Feb 28, 2011.

Thread Status:
Not open for further replies.
  1. evolve23

    evolve23 Member

    Joined:
    Mar 18, 2009
    Messages:
    17
    Can someone help me with the swivel studs for the ruger 10/22? Appleseed recommends Uncle Mike's 115 B, however, that set includes a machine screw for the forend. Why a machine screw and not a wood screw?

    Thanks in advance.

    :banghead:
     
  2. X-Rap

    X-Rap Member

    Joined:
    Sep 23, 2006
    Messages:
    6,651
    It probably also has a knurled nut that recesses into the inside barrel channel.
    Drill a small hole matching the machine screw size from the outside at your chosen position then from the inside counter bore a hole to the depth needed to flush up (+ a little) the round nut. When you screw the stud in check and make sure it doesn't make contact with the barrel, if so take it out and file the end down till it fits.
     
  3. evolve23

    evolve23 Member

    Joined:
    Mar 18, 2009
    Messages:
    17
    Thanks xrap, that's true it did come with a nut.
     
Thread Status:
Not open for further replies.

Share This Page