dashootist
Member
- Joined
- Feb 8, 2010
- Messages
- 551
Hi,
I just bought a Taurus 608. The trigger pull is absolutely the worst in the world. It also locks up when I pull the trigger or the hammer on two of the 8 rounds. I unlock it by rotating the cylinder by hand. The cylinder gap is very tight. So, after the horrible experiance at the range, I cleaned the revolver and scrubbed the front of the cylinder and the barrel. The cleaning fixed the lock-up problem. My buddy said the cylinder gap looks to be too small. So, can I use a flat file on the barrel the increase the cylinder gap?
My S&W's gap is about 3 times larger than the Taurus. And the S&W never locks up, but it spits lead.
I just bought a Taurus 608. The trigger pull is absolutely the worst in the world. It also locks up when I pull the trigger or the hammer on two of the 8 rounds. I unlock it by rotating the cylinder by hand. The cylinder gap is very tight. So, after the horrible experiance at the range, I cleaned the revolver and scrubbed the front of the cylinder and the barrel. The cleaning fixed the lock-up problem. My buddy said the cylinder gap looks to be too small. So, can I use a flat file on the barrel the increase the cylinder gap?
My S&W's gap is about 3 times larger than the Taurus. And the S&W never locks up, but it spits lead.