Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Taurus TCP 738 Frame Detail Strip Help

Discussion in 'Gunsmithing and Repairs' started by Spammy_H, Dec 10, 2012.

Thread Status:
Not open for further replies.
  1. Spammy_H

    Spammy_H Member

    Joined:
    Dec 29, 2010
    Messages:
    142
    I was swapping out the slide stop on my 738, and knocked out what I thought were the two pins holding the fire control group/block in place. Well, as it turns out, only the front pin was for the fire control group, and the back one was for the sear spring.

    As it turns out, I can't get the rear pin back in properly, and think I may have damaged either the sear spring or the hammer spring, but didn't want to go any further until seeing if anyone can offer some help on the detail strip of the frame.

    I did some research on line and only found instructions for detail stripping the slide, which is pretty straightforward. Unfortunately, I messed up the wrong half of the gun for those instructions to be of any help.

    Thanks if you can help.
     
  2. Spammy_H

    Spammy_H Member

    Joined:
    Dec 29, 2010
    Messages:
    142
Thread Status:
Not open for further replies.

Share This Page