vito
Member
I own a Lee Turret press and have a few die sets but was thinking about the PCBS hand priming tool. Just wondering if the case holder than comes with the Lee dies for each caliber will bit into this RCBS device?
NO, they will not work and I'm sure because I tried.
I have a RCBS hand priming tool and I use Lee shell holders with it all the time.
I have a RCBS hand priming tool and I use Lee shell holders with it all the time.
Did you modify anything? I looked and tried without modification and I can't see a way.me too
Or you could use the RCBS Universal and forget about shell holders altogether. I liked the first one so much, I bought a second so I can have one for large and one for small primers.
I have a RCBS hand priming tool and I use Lee shell holders with it all the time.
Ordinarily, I also have to stretch every dime as far as possible. But, since giving my old Lee primer to my mother (for rubber bullets), and I had it break on me once, I always wanted to keep a second unit handy just in case. It seemed a no-brainer to set up the universals for large and small.I wish I could spend $60 on each of 4 redundant primers but I can't. I bought the RCBS hand primer that uses shell holders because it was $20 less expensive than the universal hand primer.