1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

7.62x39 plated advice needed

Discussion in 'Handloading and Reloading' started by jeeptim, Apr 7, 2010.

Thread Status:
Not open for further replies.
  1. jeeptim

    jeeptim Member

    Mar 27, 2010
    Well here I am again with my Berry's .311/110gr Want to use em in my SKS dont want to bugger it up or get hurt.
    I have had some luck with 16.9gr of reloader 7 BUT........ at that i'm at about 1680fps and wont cycle the action mfg suggested max is 1700 fps.
    So I says to myself, self how about going a few test rounds up .5gr with a mild crimp each test untill the action cycles.
    My question is how bad could it get? is this dangrous? and so on.
    Talked with a mfg of reloaded ammo and his advise is use fmj data less 10%
    My biggest issue is dont ask me why I like reloading more then shooting and with out cheap plated bullets it cost more then new to reload.
    Also any info on pulled steel core bullets would be helpful.
Thread Status:
Not open for further replies.

Share This Page