LiveLife,
Your post is exactly right, and is technically excellent. But I'd say in this case (see what I did there?)....it may be too much? For somebody new to pistol caliber loading on a turret, finessing the dies like this is very dependent on the particular projectiles, dies, and setup he has to work with. I would definitely suggest OP errors on the side of "slight flare", as that is more the standard correct answer for pistol calibers (handgun in general in fact), and will remove a potential level of pain from inadvertently shaving bullets, or inconsistent powder drops from the case mouth not firmly hitting powder funnel, IE, different length brass. Just my .02, though I would not dispute your statement on it's technical merits.
I've run so much brass through that press I completely understand what he's saying about the flare.Thank you but my reply post #23 was not for OP rather member Hugger-4641 who posted several incorrect information.
And OP specifically asked
I appreciate all the input, thank you all very much, you've confirmed my suspicion and I shall carry on as if I had never read the incorrect input with confidence! I was very certain that cases must always be re-sized regardless of platform, it is quite possible the intent of the mentioned writing to not over do the resizing as @Carl N. Brown references, if so, that's certainly not the context I absorbed, and I appreciate all of you taking the time to clear this up!