Just something I do, that I have found stops crimped primers from getting stuck on the pin and sucked back into the primer pocket.
I put the primer pin in my drill and stone the end down to about half its diameter at the same angle as a sharpened pencil.
Then I stone a ball end onto the remaining diameter.
Not only does that stop primer sucking back into the primer pocket, but the smaller pin end can also "find" any offset flash hole easier too.
So, try it, nothing to lose,
jmo,
.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.