RMR also has a 147 gr round nose as well for those barrels that have short leades. I prefer the MW but have a few guns that I’d have to go a lot shorter in COL. I shoot the MW in competition. For practice and when I can’t shoot jacketed, I’ll either shoot the Bayou bullets 145 RN, or the Blue Bullets 147 RN - note you have to go to the “special profiles” and select the .356, otherwise their coated is .355, just FYI, whatever works for you.Interesting thanks!
It says cz pistols are known for having a short lease and those 147g RMR might not work. Anyone know about cz scorpion? I know fiochi 158g function fine.
I'm assuming Missouri Bullets.
RMR also has a 147 gr round nose as well for those barrels that have short leades. I prefer the MW but have a few guns that I’d have to go a lot shorter in COL. I shoot the MW in competition. For practice and when I can’t shoot jacketed, I’ll either shoot the Bayou bullets 145 RN, or the Blue Bullets 147 RN - note you have to go to the “special profiles” and select the .356, otherwise their coated is .355, just FYI, whatever works for you.
For SD I carry/practice with the Federal 147 HST.
Guys I shoot with swear by the 165gr extreme bullet behind a bit of Titegroup. I haven’t quite gotten there yet.
I was just going to stick with 147gr for suppressed Beretta and future 9mm carbine.
158s or 160s from a carbine might be kind of cool.
That’s unfortunate. And a perfect example of why we reloaders need to check max COL with each bullet and barrel. In the varied 9’s I have, the SA 1911 is the one that dictates my maximum length, and for the RMR 147’s, the MW max COL is 1.100 while the RN is 1.158. For all mine, the RN always has a much longer max COL. I don’t have a CZ, perhaps there’s little or no taper on the lands along with a short leade. I’m tempted to get a reamer just for that SA.Unless somethings changed, I had a terrible experience with the RMR 147RN in my CZ75 Accu-Shadow Light. I had to seat them deep enough in the case to fit my leade that it caused case bulges in about 20% of my loaded rounds
Love RMR, been meaning to try these. The 135 MW is a fine bullet as well. I load their plated 124s for run n gun steel shooting.For 147s I like the RMR Heavy Match Winners
https://www.rmrbullets.com/shop/bul...cket-heavy-matchwinner-flat-nose-bullets-new/
$90K with free shipping before the THR 5% discount.
That’s unfortunate. And a perfect example of why we reloaders need to check max COL with each bullet and barrel. In the varied 9’s I have, the SA 1911 is the one that dictates my maximum length, and for the RMR 147’s, the MW max COL is 1.100 while the RN is 1.158. For all mine, the RN always has a much longer max COL. I don’t have a CZ, perhaps there’s little or no taper on the lands along with a short leade. I’m tempted to get a reamer just for that SA.