denfoote
Member
I know how to fix it.
SPRINGFIELD!!!!!!
SPRINGFIELD!!!!!!
MIM Kimbers? Naw, you don't say. [PICS]
- Thread starter esheato
- Start date
- Status
1911Tuner
Moderator Emeritus
Springfield
denfoote said:
I know how to fix it.
SPRINGFIELD!!!!!!
Ummm...Might wanna break that puppy down and have a close look, mah fren.
Anyways...Whilst surfin' around for a little comic relief early this mornin',
I found a little more feedback on the KIM-Ber MIM-ber issue. Go see.
http://glocktalk.com/showthread.php?threadid=233530
Do I detect a trend here?
Cheers!
Tuner
denfoote said:
I know how to fix it.
SPRINGFIELD!!!!!!
Ummm...Might wanna break that puppy down and have a close look, mah fren.
Anyways...Whilst surfin' around for a little comic relief early this mornin',
I found a little more feedback on the KIM-Ber MIM-ber issue. Go see.
http://glocktalk.com/showthread.php?threadid=233530
Do I detect a trend here?
Cheers!
Tuner
Tamara
Senior Member
How come we never hear about the busted MIM parts on MIMolts, MIMfields, or MIM & Wessons? Only on MIMbers... Hmm...
1911Tuner
Moderator Emeritus
MIMolts?
LMAO...
Dunno...Other than extractors, I haven't seen an MIM part on a
Colt break yet...Maybe a better vendor...Maybe a bad run of Kimber parts?
My Colts get the MIM parts replaced soon after I get'em unless the
gun is intended to be a range toy. Then I just shoot'em 'til they break
and replace'em piecemeal. So far, with the NRM Colt, about 12,000
rounds on the MIM sear and disconnect and no problems. The extractor went south in a thousand rounds. Replaced with one of my last
Gi spring extractors. Those are gettin' scarce...
I do not TRUST MIM, Sam I am...
Tuner
LMAO...
Dunno...Other than extractors, I haven't seen an MIM part on a
Colt break yet...Maybe a better vendor...Maybe a bad run of Kimber parts?
My Colts get the MIM parts replaced soon after I get'em unless the
gun is intended to be a range toy. Then I just shoot'em 'til they break
and replace'em piecemeal. So far, with the NRM Colt, about 12,000
rounds on the MIM sear and disconnect and no problems. The extractor went south in a thousand rounds. Replaced with one of my last
Gi spring extractors. Those are gettin' scarce...
I do not TRUST MIM, Sam I am...
Tuner
nero45acp
Member
That is the reason I walked away from 1911's. Over-priced and too many QC short-cuts. I had six 1911's and everyone had one problem or another. My SIG, Beretta, and S&W revolvers are superior handguns at a fraction of the cost!!
nero
nero
- Status
