Just a general question, not looking for plans or ideas. I have a bench and a workbench in the garage. Both made with a double box frame and plywood tops.
My question was how did you allow for the press bolts. If there is a frame piece going around under the plywood top (usually double 3/4") then how did you bolt the press through that and say a 2x4 frame piece?
Lag bolts work but a bolt with a washer and nut is still stronger. Did you just use really long bolts to go through ??
Did you even use a frame piece under the edge of the top piece??
My question was how did you allow for the press bolts. If there is a frame piece going around under the plywood top (usually double 3/4") then how did you bolt the press through that and say a 2x4 frame piece?
Lag bolts work but a bolt with a washer and nut is still stronger. Did you just use really long bolts to go through ??
Did you even use a frame piece under the edge of the top piece??