atek3
Member
Moving to NH from CA one of the first things on my "to do" list was getting an AR-15. I quickly bought a few stripped stag lowers but it wasn't until last spring that I got around to putting it together.
Getting the bench organized:
modifying the stock hammer to use the JP FCS:
after drilling out the J-spring:
setting up the JP fire control system, I went with the stock hammer and hammer spring to ensure reliability:
the AR as of last spring:
Flash forward to today... I'd shot it for basically a year, and it worked flawlessly, but I really don't like the ARMS#40L as a primary aiming device. I wanted to move up to a quality red dot but it took a while to find one.
Finally I found a deal on an Aimpoint CompM2 on a Larue LT-129 and it was too perfect to pass up.
Here it is, as it is currently set up:
Parts for the curious:
Magpul MIAD
Magpul CTR
Stag Arms Lower
JP fire control system
CMMG upper assembled by Bigdawg Tactical with:
16" 1/7 stainless Medcon profile barrel
mid length gas
A2 Front Sight
Daniel Defense 9.0 foreend
ARMS 40L
Aimpoint CompM2
Larue LT-129 mount
atek3
Getting the bench organized:
modifying the stock hammer to use the JP FCS:
after drilling out the J-spring:
setting up the JP fire control system, I went with the stock hammer and hammer spring to ensure reliability:
the AR as of last spring:
Flash forward to today... I'd shot it for basically a year, and it worked flawlessly, but I really don't like the ARMS#40L as a primary aiming device. I wanted to move up to a quality red dot but it took a while to find one.
Finally I found a deal on an Aimpoint CompM2 on a Larue LT-129 and it was too perfect to pass up.
Here it is, as it is currently set up:
Parts for the curious:
Magpul MIAD
Magpul CTR
Stag Arms Lower
JP fire control system
CMMG upper assembled by Bigdawg Tactical with:
16" 1/7 stainless Medcon profile barrel
mid length gas
A2 Front Sight
Daniel Defense 9.0 foreend
ARMS 40L
Aimpoint CompM2
Larue LT-129 mount
atek3