1. Do not use "Bore Butter" as a CLP Period
2. Thoroughly clean the barrel/vent with soapy water and dry patch out.
3. Remove lock/flint & thoroughly scrub the lock inside/out with soapy water/toothbrush. Dry in "warm" oven
3. Run a wet patch (Mobile-1 synthetic) down the barrel/vent/lock/outside surfaces, etc
4. Re-seat the flint to properly engage frizzen/tighten
You are DONE between shooting sessions.
Hunt morning:
1. Thoroughly dry patch everything out/including frizzen surface.
2. Run two flash-in-the-pan rounds to set up consistent ignition later on, then wipe pan clean/close frizzen on a dry patch
Hunt area:
1. Load normally/charge pan/close frizzen
(I suggest a semi-dry patch strip that has been wetted with 7:1 water/cutting oil
and allowed to thoroughly dry. Use as-is after that, cut at muzzle)
2. Swab 2X (only) after shot with a spit/damp-only patch.
3. Reload/reprime
Follow this regimen and your first shot will be within an inch of all succeeding shots.