tyeo098
Member
So you're not going to drill & tap a rail in place?
From the looks of it you might run into trouble with the bolt handle, it should be muuuuch flatter in that first 'knuckle' otherwise its going to knock the bottom of your scope. If i were you, id cut off that first 1/2 inch or so from the shaft, and weld that on there, so its more flush. You'd have to cut a notch in your stock to accommodate that though.
But that's just me being paranoid about clearance.
From the looks of it you might run into trouble with the bolt handle, it should be muuuuch flatter in that first 'knuckle' otherwise its going to knock the bottom of your scope. If i were you, id cut off that first 1/2 inch or so from the shaft, and weld that on there, so its more flush. You'd have to cut a notch in your stock to accommodate that though.
But that's just me being paranoid about clearance.