Ritchie
Member
Does anyone know the mounting thread on the RCBS Uniflow powder measure? It appears that the mounting plate with threaded hole is not available separately.
7/8-14 same as dies but if you’re making a stand it’s about as easy to buy a 1-1/4-12 nut and a Lee or Hornady quick change bushing.Then you can turn the measure 1/4 turn or whatever and dump it.Lot quicker than running the powder thru the measure
Here’s what I’ve done with a Lee stand and a couple of spare nuts.
You will thank me later
All the plate does is hang it over the bench, how useless.
https://www.amazon.com/RCBS-Advanced-Powder-Measure-Stand/dp/B004TEZH6A
While I too have that very stand and it is handy as heck, I always thought that the mounting bar was for mounting the measure to the press like this.......
View attachment 1117223
While I too have that very stand and it is handy as heck, I always thought that the mounting bar was for mounting the measure to the press like this.......
View attachment 1117223
I really like Hornady's L-N-L stand. A L-N-L bushing on each powder measure a it's quick and easy to change measures and empty the hoppers.
This is a first!Old aluminum sander disc. No wrenches required,tough to describe but they get very tight.... yet,give one a twist and enough clearance is created that the bttm nut spins off(to dump).
View attachment 1117396