1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Alumagrips for Taurus PT1911 ?

Discussion in 'Handguns: Autoloaders' started by Steeltown Joe, Jan 11, 2010.

Thread Status:
Not open for further replies.
  1. Steeltown Joe

    Steeltown Joe Member

    Jul 13, 2009
    Pittsburgh PA.
    Anyone use Alumagrips on your Taurus PT1911 ? Just bought a Ruger MKIII Target with checkered Aluminum grips and really like the look and feel of them and I'm looking to get a set for my PT1911. The Ruger has Hogue grips but a quick check on the Hogue website says trimming may be needed to fit PT1911.
    They don't list for ambi safety. That is probally why they need trimmed. I would like to get a "bolt on' set if I can. I always seem to go too far with the Dremel.
    Alumagrips can be ordered for ambi frame or ambi frame w/magwell for an extra $2.55. Anyone use them ? What about the grip screws ? Thanks !


    Attached Files:

    Last edited: Jan 12, 2010
Thread Status:
Not open for further replies.

Share This Page