TheCracker
Member
Just picked up my much anticipated M&P 9mm shield las week. I shot about 75 rounds through it yesterday. It was 100% reliable and shot very well for a sub compact.
However, after returning home and inspecting my brass I noticed lt had bulged quite a bit of the brass i had shot.
It appears the feed ramp was cut incorrectly into the bottom of the chamber.
Apparently this is not isolated to me as I found this on another forum. These picks are exactly what mine is doing.
http://smith-wessonforum.com/smith-...ed-w-pictures-new-shield-chamber-problem.html
I will be calling S&W next week and was wondering if anyone else has had this problem and if smith had resolved it.
It is bulging cases bad enough to where I would expect a failure eventually.
However, after returning home and inspecting my brass I noticed lt had bulged quite a bit of the brass i had shot.
It appears the feed ramp was cut incorrectly into the bottom of the chamber.
Apparently this is not isolated to me as I found this on another forum. These picks are exactly what mine is doing.
http://smith-wessonforum.com/smith-...ed-w-pictures-new-shield-chamber-problem.html
I will be calling S&W next week and was wondering if anyone else has had this problem and if smith had resolved it.
It is bulging cases bad enough to where I would expect a failure eventually.